New seats-Help needed!
#1
New seats-Help needed!
Ok fitted a set of spec c seats into my wrx. 10/10 improvement btw. So i disconnected the seat air bags cos the new seats dont have them in the new seats but now the airbag warning light is up now (which i expected) but how do i cancel this? Short the wires or fit a resistor (what ohms?) help would be appreciated! Cheers
Ollie
Ollie
#7
I did this on the Forester, was dead easy.
Get some resistors from Maplins, 3 ohm sounds right from memory. Fold the wires over double and insert them into the connector for the airbags, bit of electrical tape to keep it all secure and Bobs your proverbial..
Get some resistors from Maplins, 3 ohm sounds right from memory. Fold the wires over double and insert them into the connector for the airbags, bit of electrical tape to keep it all secure and Bobs your proverbial..
Trending Topics
Thread
Thread Starter
Forum
Replies
Last Post
MH-Racing
Subaru Parts
18
18 October 2015 04:49 PM
robbie1988
Wanted
2
13 September 2015 09:25 AM
Scooby-Doo 2
Wheels And Tyres For Sale
1
09 September 2015 06:51 PM