DirtyScooby

I've purchased one and its ready to go on, so whats the procedure?

Is it a simple case of unbolting the original and just putting the sti intercooler on

stuart74

Yes pretty much, just fitted one to mine last week very impressed with the out come

andythejock01wrx

Really just a matter of undoing a couple of bolts and a couple of jubilee clips.

Hopefully you have the red rubber "Y-piece" from the STi. Take care not to damage the narrow pipe on the left of the intercooler (above the turbo), as doing so will **** up your boost.

anthscooby01

Really its a bit more than that. WRX undertray on bonnet will not fully feed STI intercooler and will prob throw hot air into it. You need to adapt undertray to seal STI intercooler so it only receives cooled air from bonnet scoop. I did it and was quite amazed at increase in ponies!

DirtyScooby

Thanks for the replies guys, most helpful and yes I have the Y pipe aswell as samco hoses.

Anthscooby01

How did you adapt it

MazingerZ

got to modify the hight of the clutch fluid reservoir (i think)

zs_phil

iTrader: (1)

was thinking of doing the same on my wrx ,how many ponies will it increase if any

FLAT ERIC

iTrader: (1)

Only on the earlier models. And the coil pack mount has to be modded on MY00.

https://www.scoobynet.com/projects-4...0-classic.html

Straight bolt on for Blobeyes though.



Mark

andythejock01wrx

I obtained the part number for an 02 STi scoop undertray by using the engine no & reg no from someone off of here. It fitted under my 01 WRX scoop, perfectly and without modification.

Novtec1

Put my sti ic on my wifes bugeye, had to get a longer throttle body hose and cover up the ac line behind it but i pretty much went right on

The Trooper 1815

iTrader: (31)

Couple of knuckle scraps but a piece of wee wee, try and get the pink y pipe too.

Got up to 269BHP/334Nm with a map, filter,3 port and the IC at PS.

STi undertray was £30 from Jap Performance Parts : Home next day delivery if they are in stock.