pre face lift change
#4
With the bonnet open, looking down on top of the grill there are two holes on either side near the headlights.
If you look down into the holes you'll see the release tabs for a plastic snap clip that attach the grill to the headlight. Using a screwdriver you can press the tabs to release the clip, at the same time as pressing the tab you want to pull the grill back slightly to release it.
Once you have released the clips the grill needs to be pulled forward slightly and then up to remove the two locating lugs that are part of the grill moulding and go down vertically into sockets in the headlight surround
If you look down into the holes you'll see the release tabs for a plastic snap clip that attach the grill to the headlight. Using a screwdriver you can press the tabs to release the clip, at the same time as pressing the tab you want to pull the grill back slightly to release it.
Once you have released the clips the grill needs to be pulled forward slightly and then up to remove the two locating lugs that are part of the grill moulding and go down vertically into sockets in the headlight surround
Last edited by Tim W; 11 November 2007 at 11:23 AM.
Thread
Thread Starter
Forum
Replies
Last Post
Sam Witwicky
Engine Management and ECU Remapping
17
13 November 2015 10:49 AM