gaz c

hello all.

i will be removing my low level spoiler soon and i need some advise as to how to do it.

is it just a mater of removing the nuts and pulling it off. will it be stuck on with somthing. its been on since new (95 wrx). have any of you out there done this and had any problems if so can you let me no please.

my new spoiler will be a mid level sti v4. i assume this will bolt strate on???

many thanks gaz c.

Daft Lad

The V4 should go straight on using the existing holes mate. When taking the old one off once you've got the bolts off, use a hairdryer just to gently heat any glue that may also be holding the spoiler in place, this should make it peel off very easily. Good luck mate

theotherphil

I'm going the other way - replacing the v4 spoiler on my MY95 with a BMW (cough) 3 series coupe M spoiler. Hoping the V4 comes off easily enough!

hoskib

iTrader: (1)

going back a bit when i took off my high level (std on MY99) but IIRC there 2 bolts each side (one under the rubber stopper) take these off and all that's left holding it on is a plastic fixing at the front edge.

this is like a plastic pin with a ball on the end so it takes a bit of effort to pop it out, no glue just a rubber gasket under the feet of the spoiler so it doesn't mark the boot.

direct swap, 10 mins tops