ste666

hi all. can any one give mesome advice on fitting my p1 splitter.i know its no
head wrecker,just some pinters on best way to fit properly

RB5 69

iTrader: (1)

I firstly added foam stripping along the edges of the splitter to stop it rubbing against the bumper and then attached it using a nut and bolt on each corner, through the arch part of the bumper (circled in red), 3 screws at the back of the part under the number plate (circled in green) and 2 screws underneath, from the corner of the splitter into the undertray of the engine, pulling it tight (circled in blue). Doing it this way without bonding, means that it can be easily removed i.e. for repainting!!

ste666

thanks mate.sweet motor u got there .hope my rb5 comes near to that.is it a wr version

yam got a scooby

As he said really or you can just screw it at the wheel arches and under the number plate. then bond it aswell.

RB5 69

iTrader: (1)

Thanks mate!!

Strictly speaking, no .... but it does have the PPP and the WRC rear spoiler, so all its missing is "WR Sport" written on the dials!

What number is your RB5??

Do you know about the RB5 Owners Club? .... www.rb5oc.co.uk .... well worth joining! .... anything you need to know about an RB5 can be found in the forums .... http://rb5oc.ipbhost.com/index.php?act=idx

Also, if you havent already done so, could you please register your car on the club registry at http://www.rb5oc.com/registerform.asp

Cheers,

Norm.