dawes type device need help
#1
dawes type device need help
I have today fitted the dawes type device to my car. (its not made by dawes but is basically the same thing)
It is fitted between the actuator pipe and the pipe coming from the turbo neck.
Problem is I cannot get it to go any lower than 15-16 psi.. i have screwed the thing right out... because of the boost pressure i am hitting I’m also triggering the fuel cut.
should it be doing this.?
Will
It is fitted between the actuator pipe and the pipe coming from the turbo neck.
Problem is I cannot get it to go any lower than 15-16 psi.. i have screwed the thing right out... because of the boost pressure i am hitting I’m also triggering the fuel cut.
should it be doing this.?
Will
#4
Scooby Regular
do you have it the wrong direction???
it will have a small ball in the end that should point towards the turbo neck..........with the open end towards the actuator
hope this helps, alyn
it will have a small ball in the end that should point towards the turbo neck..........with the open end towards the actuator
hope this helps, alyn
Thread
Thread Starter
Forum
Replies
Last Post
Sam Witwicky
Engine Management and ECU Remapping
17
13 November 2015 10:49 AM