struggling!
#1
struggling!
im looking for a oil pressure sender so i can get my gauge working, already have one but wont fit, anyone know were i can get one for a subaru, tried deamon tweeks but no good!
help
help
#2
Scooby Senior
iTrader: (1)
Join Date: Jun 2002
Location: Notts
Posts: 1,158
Likes: 0
Received 0 Likes
on
0 Posts
What make gauge is it ?
If is a subaru one then the main dealer will help, otherwise, you need to get a sender that is appropriately scaled to the gauge, or an exact match from someone who supplies the same gauges..
If is a subaru one then the main dealer will help, otherwise, you need to get a sender that is appropriately scaled to the gauge, or an exact match from someone who supplies the same gauges..
#4
Scooby Senior
iTrader: (1)
Join Date: Jun 2002
Location: Notts
Posts: 1,158
Likes: 0
Received 0 Likes
on
0 Posts
OK in which case if you have the wiring info for the gauge, I guess it is 3 or 4 wires ?
In which case 1 will be the power supply to the gauge, (1 possibly an earth) then the other 2 probably to the sender.
You need an appropriate 2/3 wire sender that has the same scaling as the gauge.
If ytou need to check the signal type to the gauge this can be done relatively easily with a few basic bits and bobs.
I'm sure I've already posted this somewhere in technical, try a search.
In which case 1 will be the power supply to the gauge, (1 possibly an earth) then the other 2 probably to the sender.
You need an appropriate 2/3 wire sender that has the same scaling as the gauge.
If ytou need to check the signal type to the gauge this can be done relatively easily with a few basic bits and bobs.
I'm sure I've already posted this somewhere in technical, try a search.
#6
Scooby Senior
iTrader: (1)
Join Date: Jun 2002
Location: Notts
Posts: 1,158
Likes: 0
Received 0 Likes
on
0 Posts
yes most senders are 1/4 NPT. I got mine and all the other fittings from these helpful chaps in Bedford http://www.lma-group.com/motorsport/.../products.html
The block itself is M18 IIRC, but I can't 100% remember.....
Can check sometime soon but don't have the info nearby.
The block itself is M18 IIRC, but I can't 100% remember.....
Can check sometime soon but don't have the info nearby.
Last edited by Scratch; 17 June 2005 at 09:17 PM.
Thread
Thread Starter
Forum
Replies
Last Post
Bazil_SW
Engine Management and ECU Remapping
24
21 September 2015 11:55 PM