scooby-tc

iTrader: (2)

Is there some kind of template for anyone wanting to put the sti logo on a top mount or mesh,or is it simply a case of being a bit of an artist?

talizman

iTrader: (1)

Just save the logo as a jpeg/bitmap, enlarge it to A4 size and print it off.

Cut the letters out and spray the template.

scooby-tc

iTrader: (2)

I bet you got your blue peter badge aswell i didnt think of that

where do i get the logo from

talizman

iTrader: (1)

I'll email you it

talizman

iTrader: (1)

YHM

pbee

http://logos.subaru.com/

StevieB

Daren,

If you spray a template you will probably find the paint gets down between the IC fins - resulting in a pink f**k up unless viewed from directly above

If you can get the paint onto a flat tray, I have a small etching roller which you can borrow if you want?? You then should only apply paint to the top surface of the fins I will dig it out for the Hants meet next week.

Cheers
Steve

scooby-tc

iTrader: (2)

Cheers Steve,that will be great its actually for etching the logo onto the fmic before it goes on unless theres any budding artists out there who can do this

AndyC_772

iTrader: (2)

Why not use a template and a dryish roller? There's no rule that says you have to spray it. Also hold the IC upside down if you can so that the drips fall off rather than running down between the fins.

talizman

iTrader: (1)

If you spray it properly, the paint won't run between the fins, just as you would not expect the paint to run if you were spraying a normal panel.

Apply a light haze of paint and repeat, building up coats until you have a nice deep finish.

Each coat should be "tacky" and not runny.