any ideas? leeds/bradford
#1
any ideas? leeds/bradford
Any help much appreciated,
Recently bought a second hand SS backbox off a guy on here but had some fitting issues.
The face plate is ever so slightly twisted and won't mate perfectly with the center section. (Paste holds a while but after a few weeks falls off.)
In addition It doesn't hang right and the tail pipe rubs on the bottom of the bumper.
Enough rambling! What I'm after is somewhere in the L/B area to get it slightly reworked (bent back into shape!) to fit properly.
Is this even possible? Any suggestions?
Cheers, Ritchie.
Speedy help required as going back upto the N of Scotland early next week and they don't have metal up there yet . ta.
Recently bought a second hand SS backbox off a guy on here but had some fitting issues.
The face plate is ever so slightly twisted and won't mate perfectly with the center section. (Paste holds a while but after a few weeks falls off.)
In addition It doesn't hang right and the tail pipe rubs on the bottom of the bumper.
Enough rambling! What I'm after is somewhere in the L/B area to get it slightly reworked (bent back into shape!) to fit properly.
Is this even possible? Any suggestions?
Cheers, Ritchie.
Speedy help required as going back upto the N of Scotland early next week and they don't have metal up there yet . ta.
#2
i just had an impreza back box welded to fit my legacy.
it was at
Alba tyres Geldard Rd leeds. - called Superflow
stainless welds and he did a good job.
hope this helps.
it was at
Alba tyres Geldard Rd leeds. - called Superflow
stainless welds and he did a good job.
hope this helps.
Thread
Thread Starter
Forum
Replies
Last Post
Sam Witwicky
Engine Management and ECU Remapping
17
13 November 2015 10:49 AM
MightyArsenal
Wheels, Tyres & Brakes
6
25 September 2015 08:31 PM