How do i fit a Hybrid Dawes device
#1
I own a 1995 type Ra and want to fit a JW racing dawes device
This is what I think I must do.
Near the end of the compressor wheel there is a thin pipe, I must disconnect this and tie rap it to something.
Where this pipe was connected to the turbo I should attach the Dawes device.
I must then disconnect the wastegate pipe from where it fixes at the other end, and block it by putting a thick screw in and clamp it using a small jubilee clip
Please let me know if this is correct.
And what boost should I run with a tdo5h turbo with optimax and an octane booster???
Thanks
This is what I think I must do.
Near the end of the compressor wheel there is a thin pipe, I must disconnect this and tie rap it to something.
Where this pipe was connected to the turbo I should attach the Dawes device.
I must then disconnect the wastegate pipe from where it fixes at the other end, and block it by putting a thick screw in and clamp it using a small jubilee clip
Please let me know if this is correct.
And what boost should I run with a tdo5h turbo with optimax and an octane booster???
Thanks
Thread
Thread Starter
Forum
Replies
Last Post
JonMc
Subaru Parts
22
06 February 2016 09:50 PM
JackClark
Computer & Technology Related
3
18 September 2015 11:19 PM
matt12
Engine Management and ECU Remapping
4
14 September 2015 09:36 AM