Cherished Transfers
#1
Drag it!
Thread Starter
iTrader: (1)
Join Date: Jun 2002
Location: Flame grilled Wagon anyone?
Posts: 9,866
Likes: 0
Received 0 Likes
on
0 Posts
Just walked down into Leeds to finally change my number plate to the above.
Christ why can people not read forms and complete them fully before they get to the counter
waited 40 minutes because of these people, it took me 3 mins to do mine because i read the bloody form. I know they say education standards are dropping, but not being able to read is bloody ridiculous.
Anyway my scoob is now recognisable as me P20SPD
[Edited by P20SPD - 8/1/2002 2:44:34 PM]
[Edited by P20SPD - 8/1/2002 3:12:01 PM]
Christ why can people not read forms and complete them fully before they get to the counter
waited 40 minutes because of these people, it took me 3 mins to do mine because i read the bloody form. I know they say education standards are dropping, but not being able to read is bloody ridiculous.
Anyway my scoob is now recognisable as me P20SPD
[Edited by P20SPD - 8/1/2002 2:44:34 PM]
[Edited by P20SPD - 8/1/2002 3:12:01 PM]
#2
Scooby Regular
Yep, just like the ***** that make me stand behind them in the bank for most of my lunch hour because they want to pay their gas bill but are too tight to buy a stamp and post it instead [img]images/smilies/mad.gif[/img]
#5
Drag it!
Thread Starter
iTrader: (1)
Join Date: Jun 2002
Location: Flame grilled Wagon anyone?
Posts: 9,866
Likes: 0
Received 0 Likes
on
0 Posts
Congratualtions MD
suggested it could be the size of the hole in the housing unit on the blitz induction kit being smaller than the hole on maf unit. apparently just had this problem on a P1 at PE. It upsets the airflow
still not convinced though!
i am going to have a look tonight and also adjust the actuator half a turn.
good luck with new job.
suggested it could be the size of the hole in the housing unit on the blitz induction kit being smaller than the hole on maf unit. apparently just had this problem on a P1 at PE. It upsets the airflow
still not convinced though!
i am going to have a look tonight and also adjust the actuator half a turn.
good luck with new job.
Thread
Thread Starter
Forum
Replies
Last Post
alcazar
Non Scooby Related
5
18 September 2015 11:49 PM