ZANY

Hey all hope all is well

i need to replace the side badges on the gb270 spoiler as they have seen better day and I have allready ordered a pair to land next week.

My problem is how do I take the current ones off without any damage? 😬 they are right in 😢

all help and advice appreciated in advance 👍

Gsi Jay

A bit of heat and some trim removal tools made out of plastic maybe, if you can get them under the badge anyway.

Rusti

iTrader: (4)

straight edge trim tool and some heat like suggested, all you need is to get under there and then youre good to go (gently)

jaygsi

iTrader: (46)

I've taken a set off a while ago, the badge is in 2 halves. There's like a plastic panel that goes over the Prodrive badge. So you could poke a screw driver in the Centre off the badge and that should get it to come off.

As I tried a screw driver at the edge and caught some paint. So I'd try going at the centre first.

There's a screw hole in the centre of the badge if I remember correctly.

ZANY

yes mate there’s 2 hex bolts on each side under the badges

I used the advice above and worked a treat came off no problem used a plastic trimremover

then cleaned it with autoglym tar remover then put the fresh ones on 👌

thanks all much appreciated 🙏

jaygsi

iTrader: (46)

Ah the straight edge trim tool and some heat? Did you use OEM badges? I bought some replica ones off ebay.