johno01

hi all
my car has a syvecs ecu and the setting were 1.1 to 1.6bar with a immobilisor setting in there aswell...the immobilisor setting has gone and all the maps are running in 1.6 bar mode...ive not messed with any of the ecu as i wouldnt have a clue...any idea what has caused this?? it was sorned from november 2015 untill beginning of this month and i did disconnect the battery to save the battery but im sure the immobilisor setting was still working recently as i started car evey week to keep things working and it wouldnt start when left in that setting?? any help much appreciated.

yabbadoo4

iTrader: (8)

any switches fitted to change boost settings etc? mine is mapped on ecutek so rear demister switch changes the boost setting with ignition on and accelerator pushed to the floor. dont know about syvecs but im assuming there,s switches or a method to change maps etc.

johno01

yeah theres a toggle switch pal which i turn to pick which setting i want but it doesnt seem to be doing anything...not sure if its the switch or the ecu thats faulty??

yabbadoo4

iTrader: (8)

hard to say bud, the ecu wouldnt "lose" the map settings etc maybe the switch or wiring is at fault. post in the ecu/ engine management section there is a user called bludgod who is quite knowledgeable and has helped me out with mapping/ecu questions in the past

johno01

cheers matey...going to have a nosey at the wiring for the switch then will give him a shout