V7/8 Intercooler to MY94
#1
Scooby Regular
Thread Starter
Join Date: Nov 2004
Location: In a House
Posts: 108
Likes: 0
Received 0 Likes
on
0 Posts
V7/8 Intercooler to MY94
Hi Guys,
Anyone help with this project.......
My project was halted about 1hr in after I had removed all the old bits.
When I measured the distance between the bulkhead and the inlet theres
not enough room.... looks like I need another 20-30mm to be able to get it in and get the coupler!!!
Is there differences between the MY94 WRX and newer models in the inlet length???
Any Input is welcome!!!
Anyone help with this project.......
My project was halted about 1hr in after I had removed all the old bits.
When I measured the distance between the bulkhead and the inlet theres
not enough room.... looks like I need another 20-30mm to be able to get it in and get the coupler!!!
Is there differences between the MY94 WRX and newer models in the inlet length???
Any Input is welcome!!!
#2
In a word yes the inlet manifold on the old car a lot nearer the bulkhead
than on later cars The best you can do is fit a v5/6 intercooler
http://i72.photobucket.com/albums/i1...yengine011.jpg
than on later cars The best you can do is fit a v5/6 intercooler
http://i72.photobucket.com/albums/i1...yengine011.jpg
#3
Scooby Regular
Thread Starter
Join Date: Nov 2004
Location: In a House
Posts: 108
Likes: 0
Received 0 Likes
on
0 Posts
V7/8 on a MY94WRX
Cheers phil, I have completed a test fit and with the inlet manifold on the MY94, theres no chance its going on without some wild removal plan of unwanted metal.
UPDATE:
New Inlet
New Fuel rails
FSE Fuel Regulator
Next step is fitment of the inlet....
Keep u Updated
UPDATE:
New Inlet
New Fuel rails
FSE Fuel Regulator
Next step is fitment of the inlet....
Keep u Updated
Last edited by Smilbertilgy; 12 October 2006 at 09:33 PM. Reason: Update
Thread
Thread Starter
Forum
Replies
Last Post
Flat4x4-again
General Technical
2
29 September 2015 06:32 PM