help re i/cooler Q
#2
Former Sponsor
iTrader: (4)
Join Date: Jan 2001
Location: ECU Mapping - www.JollyGreenMonster.co.uk
Posts: 16,548
Likes: 0
Received 2 Likes
on
2 Posts
I believe the STi5 intercooler can be made to fit.. but think the newage intercoolers are larger still and not going to be enough room if that is the case.
JGM
JGM
#4
The 01-03 WRX intercooler fits just, but it touches the bulkhead slightly, and you have to remove the spot welds and then seal weld the bulkhead. Took bloody ages and now I've gone and bought a FMIC. You will also need to fabricate a bottom Y hose as neither fit.
Mark A
[Edited by Mark A - 12/16/2003 8:43:28 PM]
Mark A
[Edited by Mark A - 12/16/2003 8:43:28 PM]
#6
Scooby Regular
Join Date: Jul 2000
Location: Glasgow
Posts: 3,040
Likes: 0
Received 0 Likes
on
0 Posts
You can fit the later Ver7 intercooler to the *classic* Impreza.
You need to adapt between compressor out let and the Ver7 "Y" pipe under the intercooler and make up a couple of simple brackets to support the intercooler on to the engine.
Ver 5 dump valve can be fitted but better off using the ver 7's dump valve as they don't line up the same.
Clearance is very tight and is very close to bulkhead. The larger cooler also hides the clutch reservoir, so would need to come off if you want to top it up (no big deal)
Finally...would recommend making adjustments in the scoop area as the size of the aperture is smaller than the ver7 intercooler, so air going in to the cooler is less than ideal
Alan
You need to adapt between compressor out let and the Ver7 "Y" pipe under the intercooler and make up a couple of simple brackets to support the intercooler on to the engine.
Ver 5 dump valve can be fitted but better off using the ver 7's dump valve as they don't line up the same.
Clearance is very tight and is very close to bulkhead. The larger cooler also hides the clutch reservoir, so would need to come off if you want to top it up (no big deal)
Finally...would recommend making adjustments in the scoop area as the size of the aperture is smaller than the ver7 intercooler, so air going in to the cooler is less than ideal
Alan
#7
Scooby Regular
Join Date: Sep 2003
Location: I am lost. I have gone to find myself, if I should return before I get back, please ask me to wait.
Posts: 2,688
Likes: 0
Received 0 Likes
on
0 Posts
Well worth doing - better flow of air but need new undertray if u have "slanted" intercooler - subaru will supply correct bonnet undertray for about £90 of yer hard earned.....
the magic number is - DUCT COMPL I/C 90818FA160 (subaru part number)
the magic number is - DUCT COMPL I/C 90818FA160 (subaru part number)
Thread
Thread Starter
Forum
Replies
Last Post
hoskib
Drivetrain
2
03 March 2004 09:03 PM