megabusa

Can someone please tell me which pipes go where from the AMAL valve on a Cossie? Mines running like crap and I think this might be making it worse!!

dazc2

What a suprise!!

Ok...look at the ports on the amal valve...at the base of them there should be a letter which coresponds to each pipe....R is the Return to the air filter box...... C is the Compressor housing pipe and W is the Wastegate actuator pipe......

Incidently this wont make it run crap.....a Cossie will run perfectly but a little slugish with all its induction hoses off as it uses a MAP sensor and not a MAF sensor to meter air flow......the only thing that will effect air flow readings is a blowing inlet manifold gasket

m4rk rs

looking from the front of car

l/h outlet-actuator
centre outlet-turbo
r/h outlet-airbox

mark

megabusa

Thanks fellas, ecu also has Ahmed Bayjoo stage 1 chip, dont know if this is causing a problem but plugs were sooted up and it misfired like a good 'un on no. 1 and 2 cylinders. Changed all plugs and it runs again, perhaps it needs a good old thrash because engine hasnt been run for years?
BTW its on standard injectors.

dazc2

Not been run for years?.....get it warm and take it for a clearing out. If its still running badly then get it set up......

co55ie

Check the crank angle sensor.