Glass fibre release agent
#1
Glass fibre release agent
I have made some moulds for a sub install (350z, not scooby) using glassfibre. I am nearly ready to start making the acutal boxes now but not sure what to use as a release agent for coating the inside of the mold.
I have been told that a layer of PVA glue does the trick or even vaseline brushed on with a paint brush does the job?
Any advise welcomed.
Thanks, The Hoff
I have been told that a layer of PVA glue does the trick or even vaseline brushed on with a paint brush does the job?
Any advise welcomed.
Thanks, The Hoff
#3
Scooby Regular
Join Date: Feb 2005
Location: Derbyshire
Posts: 12,304
Likes: 0
Received 0 Likes
on
0 Posts
#4
I have made some moulds for a sub install (350z, not scooby) using glassfibre. I am nearly ready to start making the acutal boxes now but not sure what to use as a release agent for coating the inside of the mold.
I have been told that a layer of PVA glue does the trick or even vaseline brushed on with a paint brush does the job?
Any advise welcomed.
Thanks, The Hoff
I have been told that a layer of PVA glue does the trick or even vaseline brushed on with a paint brush does the job?
Any advise welcomed.
Thanks, The Hoff
mart
Trending Topics
#10
Scooby Regular
iTrader: (1)
Join Date: Sep 2003
Location: gravesend, kent
Posts: 4,721
Likes: 0
Received 0 Likes
on
0 Posts
we use a brush on wax demoulant from a company called axson technologies, for tricky corners and hard to reach bits we use a spray on wax called macwax.
not sure what your experience is with moulds so forgive me if i'm trying to tell you how to suck eggs but what is the finish of your mould? in other words is it non-porous as you need to seal it if it isn't
#11
Done a few glass fibre builds in the past for my old Reault 5 and Scooby but never used a gel coat. Normally I just smoothed it with P38, sanded it down, primed it is and sprayed it.
I have heard of gel coats but never known why they are required apart from a pre coloured finish.
I have heard of gel coats but never known why they are required apart from a pre coloured finish.
Last edited by The Hoff; 13 August 2008 at 09:15 PM.
#13
Scooby Regular
iTrader: (1)
Join Date: Sep 2003
Location: gravesend, kent
Posts: 4,721
Likes: 0
Received 0 Likes
on
0 Posts
Done a few glass fibre builds in the past for my old Reault 5 and Scooby but never used a gel coat. Normally I just smoothed it with P38, sanded it down, primed it is and sprayed it.
I have heard of gel coats but never known why they are required apart from a pre coloured finish.
I have heard of gel coats but never known why they are required apart from a pre coloured finish.
the reason for this is when you rub up anything that hasn't had a gel coat you get little 'whiskers' of fibreglass poking through, so if you don't want these seen when you paint it you have to fill over. so you're kind of doing everything twice.
all depends if you're doing one off stuff or a few copies
great looking work from your pics, love the colour scheme your boot must have stunk like a TVR for ages
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
12
18 November 2015 07:03 AM