Career advice (for the wife)
#1
Career advice (for the wife)
My wife currently makes curtains and blinds, part time and looks after the kids, it doesn't pay much considering the skill involved so she is looking to do something else at some point.
Still a few years of kids being dependent, youngest is eight but in say four years he will be getting the bus to school and she wont have to collect every night, so that gives a few years to train in something new and hopefully more lucrative, I am currently earning good money but its a lot of pressure being the only breadwinner adn who is to say it will last.
So any (clean) suggestions for work that will fit around school holidays and the family commitments in general and pay a reasonable amount, as opposed to minimum wage.
Still a few years of kids being dependent, youngest is eight but in say four years he will be getting the bus to school and she wont have to collect every night, so that gives a few years to train in something new and hopefully more lucrative, I am currently earning good money but its a lot of pressure being the only breadwinner adn who is to say it will last.
So any (clean) suggestions for work that will fit around school holidays and the family commitments in general and pay a reasonable amount, as opposed to minimum wage.
#2
does she have any qualys??
look at what here strengths are, and see if you can apply those to other business areas..
why not set up from home?
another one thats a good earner and easy to do is balloon -stuff weddings etc...
a friend of mine used to do it... made some pretty serious money ..
mind you it is mainly evenings and weekends
Mart
look at what here strengths are, and see if you can apply those to other business areas..
why not set up from home?
another one thats a good earner and easy to do is balloon -stuff weddings etc...
a friend of mine used to do it... made some pretty serious money ..
mind you it is mainly evenings and weekends
Mart
Thread
Thread Starter
Forum
Replies
Last Post
Sam Witwicky
Engine Management and ECU Remapping
17
13 November 2015 10:49 AM
Phil3822
General Technical
0
30 September 2015 06:29 PM