Pic request - gauges in your blobeye ??
#1
Scooby Regular
Thread Starter
iTrader: (8)
Join Date: Sep 2002
Location: Fife - Scotland
Posts: 4,455
Likes: 0
Received 0 Likes
on
0 Posts
Pic request - gauges in your blobeye ??
Guys, looking for some pictures off side mounted / dash mounted gauges within a blobeye wrx ?? having just got some gauges earlier on today will be looking for a nice reasonably priced 3 gauge pod not decided if to go dash or side mounted yet - any advantages / disadvantages between the two ?? any ebay recommendations for a source off pod ??
thanks folks
thanks folks
#2
Scooby Regular
iTrader: (23)
Join Date: Jan 2010
Location: Bedfordshire
Posts: 1,642
Likes: 0
Received 0 Likes
on
0 Posts
Be careful of the ebay dash triple pods (the cheap ones), they're known not to really match the colour of your dash. You might be better spending a few extra penys and buying off someone like scoobyparts / scoobyworld.
cheers
cheers
Trending Topics
#8
Scooby Regular
iTrader: (2)
Join Date: Dec 2004
Location: East Sussex
Posts: 1,106
Likes: 0
Received 0 Likes
on
0 Posts
Be careful of the cheapy ones, as already said, they dont match and most of the time dont fit properly either. I had two before finally paying the money and going for an ATI one
Had this one before it which I really liked as it blended in nicely and was alot more subtle than the ATI one, but could never get it to fit properly, and then it warped in the heat.
Had this one before it which I really liked as it blended in nicely and was alot more subtle than the ATI one, but could never get it to fit properly, and then it warped in the heat.
#11
Scooby Regular
Thread Starter
iTrader: (8)
Join Date: Sep 2002
Location: Fife - Scotland
Posts: 4,455
Likes: 0
Received 0 Likes
on
0 Posts
Anyone share there pillar mounted pod pictures fitted in blobeye ??
now thinking off going for side mounted with a flocked oe colour finish- just need to match the colour off the dise trim- anyone advise what the nearest match is ??
now thinking off going for side mounted with a flocked oe colour finish- just need to match the colour off the dise trim- anyone advise what the nearest match is ??
#12
Scooby Regular
iTrader: (6)
Join Date: Aug 2007
Location: Llanelli with a spanner in my hand!
Posts: 2,260
Likes: 0
Received 0 Likes
on
0 Posts
Yep, they are prosports, I got Boost, oil temp and oil pressure. No problems with gauges, I did have and issue with one of the sensors snapping when I fitted them, so had to pick up a new one.
#13
Scooby Regular
Thread Starter
iTrader: (8)
Join Date: Sep 2002
Location: Fife - Scotland
Posts: 4,455
Likes: 0
Received 0 Likes
on
0 Posts
Okay cheers for the info, guys been advised that the sensor for the alarm is within the pillar and that it would required re allocated if fitting a side pillar pod, anyone confirm ?? not sure why it would require moved but if this is the case just wonder if there is nuch involved ??
#14
Scooby Regular
iTrader: (9)
I have an a-pillar single pod (boost) mounted in the very corner, prosport gauge. Very happy with it, no problems. As you mentioned I believe you would have to move the alarm sensor, but I can't see that being a massive job, just a case of moving it up and re-drilling. Mind you I'm not sure how long the cabling for it is behind?