Show us your Header 'Porting'
12 July 2006, 04:54 PM
#1
Show us your Header 'Porting'
Half way through porting my headers, fast running out of enthusiasm and waiting for some Carbide burrs to arrive.
Do you port both sides of the headers and cross-over pipe i.e 'Flow-In' anf 'Flow-Out' or just the 'flow-in' side.
Please show me your efforts
Do you port both sides of the headers and cross-over pipe i.e 'Flow-In' anf 'Flow-Out' or just the 'flow-in' side.
Please show me your efforts
Last edited by Scott.T; 12 July 2006 at 10:05 PM.
16 July 2006, 04:37 AM
#2
Scooby Regular
iTrader: (4)
Join Date: Sep 2005
Location: The yorkshire dales - best roads in the UK
Posts: 3,311
Likes: 0
Received 0 Likes
on
0 Posts
Scott, Sorry no pics of cross section, you only need to port in the direction of flow, do not port out the face were the gases are leaving...if that makes sense. You will proberbly find some snotty welds on the cross section, make sure you grind them all flat.
Last edited by T5OLF; 16 July 2006 at 04:45 AM.
16 July 2006, 08:09 PM
#3
cheers mate, thought as much w.r.t exiting flow. Suits me, as I'm further through completing then 
as have done most of the off-side and part of the cross-over before my rotary files went blunt.
Carbide Burrs should arrive tommorrow, so I can crack on.....
as have done most of the off-side and part of the cross-over before my rotary files went blunt.Carbide Burrs should arrive tommorrow, so I can crack on.....
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
28
28 December 2015 11:07 PM
Mattybr5@MB Developments
Full Cars Breaking For Spares
12
18 November 2015 07:03 AM
Sam Witwicky
Engine Management and ECU Remapping
17
13 November 2015 10:49 AM