show and tell.......
Trending Topics
#8
Scooby Regular
Thread Starter
Join Date: Feb 2001
Location: Hemel Hempstead
Posts: 7,953
Likes: 0
Received 0 Likes
on
0 Posts
Cheers Ian
Dunc20 - The plates were made by my local sign company, the front was a std size plate with the slightly smaller lettering, i cut it down and rounded the edges. The rear is a std import sized plate, I dont like it though, Im going to remove the hangers and put on a std uk rear plate. Unfortunatley they cannot make plates with non std size lettering anymore.
Hi Alex, hows tricks mate? Yup I have a set of MRT springs on order, not going for the 80mm drop I had on the other car, a little too extreme
Hi Dan! Cheers mate, it is totaly mint, not a mark on it, not dents, not scratches etc....
Bondy, 18s have to be done mate, other sizes just dont measure up apart from 19s, obviously!
Wannabe - Keep you eyes open in the forsale section, these are quite rare beasties.... esp one as nice as mine
Thanks all
Dunc20 - The plates were made by my local sign company, the front was a std size plate with the slightly smaller lettering, i cut it down and rounded the edges. The rear is a std import sized plate, I dont like it though, Im going to remove the hangers and put on a std uk rear plate. Unfortunatley they cannot make plates with non std size lettering anymore.
Hi Alex, hows tricks mate? Yup I have a set of MRT springs on order, not going for the 80mm drop I had on the other car, a little too extreme
Hi Dan! Cheers mate, it is totaly mint, not a mark on it, not dents, not scratches etc....
Bondy, 18s have to be done mate, other sizes just dont measure up apart from 19s, obviously!
Wannabe - Keep you eyes open in the forsale section, these are quite rare beasties.... esp one as nice as mine
Thanks all
#21
Scooby Regular
Thread Starter
Join Date: Feb 2001
Location: Hemel Hempstead
Posts: 7,953
Likes: 0
Received 0 Likes
on
0 Posts
Broadmoor - **** off!
Cheers Dunk/Mikey
ice man, got a good deal on the clears, I still think they were a little on the expensive side. love a deal!
Cheers Dunk/Mikey
ice man, got a good deal on the clears, I still think they were a little on the expensive side. love a deal!
Thread
Thread Starter
Forum
Replies
Last Post
Sam Witwicky
Engine Management and ECU Remapping
17
13 November 2015 10:49 AM
Phil3822
General Technical
0
30 September 2015 06:29 PM