clifford concept 300
#1
Scooby Newbie
Thread Starter
Join Date: Mar 2012
Location: hitchin
Posts: 4
Likes: 0
Received 0 Likes
on
0 Posts
clifford concept 300
this is an old alarm and i have never had any dresire to change anything with it as it worked fine, but had been disconnected for about a year while i did a rebuild,
it has powered up nicely and works well but i wanted to change the autolock to off,
put in valet code and red led stays on, but then it wont accept the * button press to go into programming mode , can anyone let me know if this is a faulty alarm, or do you think its cos of battery in soren being flat for so long ?
ill run it for a while and see how it behaves afeter that , but am i doing somethiung wrong ?
thanks for a great forum very informative
trev
it has powered up nicely and works well but i wanted to change the autolock to off,
put in valet code and red led stays on, but then it wont accept the * button press to go into programming mode , can anyone let me know if this is a faulty alarm, or do you think its cos of battery in soren being flat for so long ?
ill run it for a while and see how it behaves afeter that , but am i doing somethiung wrong ?
thanks for a great forum very informative
trev
#3
Scooby Newbie
Thread Starter
Join Date: Mar 2012
Location: hitchin
Posts: 4
Likes: 0
Received 0 Likes
on
0 Posts
thanks i have that manual and done all thre button presses, it goes into valet mode well i assume it is as the led goes on solid but wont accepy any more button presses to go into program mode ? any ideas
trev
trev
#5
Scooby Newbie
Thread Starter
Join Date: Mar 2012
Location: hitchin
Posts: 4
Likes: 0
Received 0 Likes
on
0 Posts
thanks yes i have tried a lot, and it says hold the * button of the plainview switch is this wrong then and should i be holding the plain one instead ?
trev
trev
#6
paragraph 4 ".....press and release the unmarked button of the plainview 2 switch...." was what I was looking at
it is a damn complicated way of doing things
If I have time tomorrow, I will have a go at chaning mine and let you know how I get on...
Last edited by albob; 12 March 2012 at 11:28 PM.
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
28
28 December 2015 11:07 PM
shorty87
Full Cars Breaking For Spares
19
22 December 2015 11:59 AM