classic heater control bulbs
09 November 2011, 10:29 PM
#2
Scooby Regular
iTrader: (3)
Join Date: Jan 2003
Location: Oss, The Netherlands
Posts: 749
Likes: 0
Received 0 Likes
on
0 Posts
Small wire type.
I replaced them with LED's, as the first repair (with the above type bulbs) did work perfectly for give or take 2 weeks.The bulbs are very fragile, and also they get very hot inside the switch.This causes them to go out very easily I believe, as my model railway uses the same bulbs, and I have no problems with the bulbs there.
It's quite easy if you have some soldering skills, and the illumination is much nicer as well.
I replaced them with LED's, as the first repair (with the above type bulbs) did work perfectly for give or take 2 weeks.The bulbs are very fragile, and also they get very hot inside the switch.This causes them to go out very easily I believe, as my model railway uses the same bulbs, and I have no problems with the bulbs there.
It's quite easy if you have some soldering skills, and the illumination is much nicer as well.
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
28
28 December 2015 11:07 PM
supshon
General Technical
2
03 October 2015 08:06 PM
jonnyboy82
Lighting and Other Electrical
0
29 September 2015 01:59 PM
