How easy are hid too fit???
12 September 2010, 09:19 AM
#2
easy as pie well they are on all the cars ive done so cant imagine them being any harder on urs, if ur local to me i can give u a hand/ fit em for u, but the basics are, n the kit ull have ur ballasts which locatin a good place for them is the tricky bit as they dont give you lots of slack in the wires, all thats is involved is.
1) finding some where to mount / secure ballast any where dry will do even cable tie them to something if ur not to fussy bout it being tidy,
2) the wiring is simple as this, you will have 1 Red positive wire that goes to ur battery, normally a black negative for each ballast, can be earthed out any where, and on one ballast a plug that plugs in to the connector that orignally use to plug on to the bulb (3 pin / 2 pin etc. )
Done. pretty much can be a five minute job if u dont wanna do it tidy just takes time to fiddle wires about locate good place for ballast most ppls cars that ive done have just put in side inner wings, side of batteries, taken headlight out n put ballast underneath.) i personally try n keep them accessable so it is easy to remove or change ballast or bulbs if one ever fails or suddenly has a dodgy contection u can get to it with ease to wiggle the wire till it works lol. hope this helps.
1) finding some where to mount / secure ballast any where dry will do even cable tie them to something if ur not to fussy bout it being tidy,
2) the wiring is simple as this, you will have 1 Red positive wire that goes to ur battery, normally a black negative for each ballast, can be earthed out any where, and on one ballast a plug that plugs in to the connector that orignally use to plug on to the bulb (3 pin / 2 pin etc. )
Done. pretty much can be a five minute job if u dont wanna do it tidy just takes time to fiddle wires about locate good place for ballast most ppls cars that ive done have just put in side inner wings, side of batteries, taken headlight out n put ballast underneath.) i personally try n keep them accessable so it is easy to remove or change ballast or bulbs if one ever fails or suddenly has a dodgy contection u can get to it with ease to wiggle the wire till it works lol. hope this helps.
Thread
Thread Starter
Forum
Replies
Last Post
JonMc
Subaru Parts
22
06 February 2016 09:50 PM