FITTING HKS FCD
#1
Hi i have fitted an HKS FCD to my 92 wrx i am using an apexi boost controller.the fcd worked for a while then started cutting again i have it wired properly but when i check the voltage on the live wire it is putting out 12 volts i know it only meant to run on 5 volts could i have damaged the fcd,the car runs fine with the fcd on but it cuts some times and not others.can anyone advise on correct voltage and settings of the fcd i had it set on 10 on the fcd. Johnny
Thread
Thread Starter
Forum
Replies
Last Post
Scott@ScoobySpares
Full Cars Breaking For Spares
61
11 January 2021 03:08 PM
Mattybr5@MB Developments
Full Cars Breaking For Spares
33
29 August 2017 07:18 PM
blockhead
Subaru Parts
19
07 November 2015 11:50 PM