Head unit wiring advice please!
#1
Scooby Regular
Thread Starter
Join Date: Apr 2002
Location: Bournemouth - 5x Ex Impreza owner. 997 GT3 CS.
Posts: 7,333
Likes: 0
Received 0 Likes
on
0 Posts
Head unit wiring advice please!
I have an STi5 and the head unit has been removed. Unfortunately all the wires were snipped rather than the loom connector plug being left in.
I need to put a kenwood mask in there, but dont know any of the wiring colours from the Subaru loom. I have the Kenwood ones from the manual.
Once I do know how to wire it, whats the best way? The Kenwood has the Jap convertor plug attatched so I could wire that straight to the Subaru loom so it will then have a plug on the end.
Also, the cage for the original double DIN unit has gone. Its the one that screws into the sides of the dash.
I cant fit the Kenwood without it I dont think. Where can I get a new cage?
Help!
MB
I need to put a kenwood mask in there, but dont know any of the wiring colours from the Subaru loom. I have the Kenwood ones from the manual.
Once I do know how to wire it, whats the best way? The Kenwood has the Jap convertor plug attatched so I could wire that straight to the Subaru loom so it will then have a plug on the end.
Also, the cage for the original double DIN unit has gone. Its the one that screws into the sides of the dash.
I cant fit the Kenwood without it I dont think. Where can I get a new cage?
Help!
MB
#3
Scooby Regular
Thread Starter
Join Date: Apr 2002
Location: Bournemouth - 5x Ex Impreza owner. 997 GT3 CS.
Posts: 7,333
Likes: 0
Received 0 Likes
on
0 Posts
All sorted. Got a wiring diagram and used bullet connectors to wire to the Kenwood plug. Now just have to get an original double din cage to fit into the gap, then I can bolt the Kenwood in....
MB
MB
Thread
Thread Starter
Forum
Replies
Last Post
hedgecutter
General Technical
3
25 September 2015 02:35 PM