Changing bulbs on MY99 with Morettes
#2
Scooby Regular
iTrader: (3)
Join Date: Dec 1999
Location: UK
Posts: 13,274
Likes: 0
Received 0 Likes
on
0 Posts
Chris,
The bulb holder is at an angle! You will find the usual two clip design for holding in H4 bulbs, and unclip from the bottom, and are hinged on the top.
I did mine in a dark pub car park, and it was raining!! Ask anyone at that Bagshott meet!
You should be able to access the drivers side without removing the battery! Depends how fat your hands are!!
Hope this helps
Andy
The bulb holder is at an angle! You will find the usual two clip design for holding in H4 bulbs, and unclip from the bottom, and are hinged on the top.
I did mine in a dark pub car park, and it was raining!! Ask anyone at that Bagshott meet!
You should be able to access the drivers side without removing the battery! Depends how fat your hands are!!
Hope this helps
Andy
#3
Moderator
Thread Starter
Join Date: Dec 1998
Location: Staffs
Posts: 23,573
Likes: 0
Received 0 Likes
on
0 Posts
Cheers Andy.
Job's a good un. The wire 'brackets' on my Morettes hinge from the bottom and clip round at the top.
Knuckles fairly intact as well
Ta,
ChrisB.
Job's a good un. The wire 'brackets' on my Morettes hinge from the bottom and clip round at the top.
Knuckles fairly intact as well
Ta,
ChrisB.
Thread
Thread Starter
Forum
Replies
Last Post
Sam Witwicky
Engine Management and ECU Remapping
17
13 November 2015 10:49 AM
jonnyboy82
Lighting and Other Electrical
0
29 September 2015 01:59 PM