Phil_Macefield

I'm in the middle of getting my Ver2 STi sorted for the S.V.A and have stripped most of the interior to put in wiring etc for the alarm and fog light etc. But when I took off the trim on the drivers side under the steering rack I noticed two conectors were not connected looking as if they should be? Two wires on each end of both sockets each with one black wire and one black and red wire.

Could they be to do with the turbo timer?

What are these?

Should I connect them?

What do they do?

Help!

Phil_Macefield

Sorry guys made a mistake there is only one wire at each end of both the connectors which is black and red.

The connectors at each end are black!

Anyone help what are they.

andyr

I think these are the connectors that are used to reset the ecu - I haven't had a good look for these yet on my own MY95 WRX but might do so this week.

Mal26

You should have 2 black and 2 green connectors.