How do i use a U.K. Fog light switch with a third party fog light?
#1
Hello all new member to the forum have been looking aroung and there is some very helpfull info on here so keep up all the good work everybody.
I have a 1996 WRX Import and want to use a Original U.K. Rear fog light switch with a third party fog light , The current setup is there 3 wires going to the switch 1 Illumination 1 Earth and 1 Switch. Upon looking on the back of the U.K. Switch I have noticed there are 6 pins protruding how I know what wires I have to connect where? Thank you for any help.
Gfunk
I have a 1996 WRX Import and want to use a Original U.K. Rear fog light switch with a third party fog light , The current setup is there 3 wires going to the switch 1 Illumination 1 Earth and 1 Switch. Upon looking on the back of the U.K. Switch I have noticed there are 6 pins protruding how I know what wires I have to connect where? Thank you for any help.
Gfunk
#2
Scooby Regular
Join Date: Dec 1999
Location: Aberdeen
Posts: 658
Likes: 0
Received 0 Likes
on
0 Posts
This might help
What I did was connect the illuminate from the other switches to 2 & 4. The rear fog light gets power from the tail lights and connects to pin 1 then earths thru pin 5.
This way the rear fog only comes on when you have lights on.
[Edited by Ken Ross - 9/29/2003 12:59:45 AM]
What I did was connect the illuminate from the other switches to 2 & 4. The rear fog light gets power from the tail lights and connects to pin 1 then earths thru pin 5.
This way the rear fog only comes on when you have lights on.
[Edited by Ken Ross - 9/29/2003 12:59:45 AM]
#3
Hi Ken just been trying to wire the rear fog light and switch up but i'm having a few problems. The switch in the front illuminates on and off but the fog light on the rear of the car stays on. Any Ideas on what might be wrong?. I have connected the illuminate from the front fog light switch to pins 2&4 and i linked a wire from the + of the Rear lights to the + on the fog light switch then connected it to pin 1. Then connected a earth from the body of the car to pin 5 then run the cable down to the - of the fog light switch.
Cheers for any help.
Gfunk
Cheers for any help.
Gfunk
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
28
28 December 2015 11:07 PM
Mattybr5@MB Developments
Full Cars Breaking For Spares
12
18 November 2015 07:03 AM