Rear 'Lexus' Style Lamp Taking On Water on MY01
#1
I have fitted rear lexus style lamps to MY01 WRX. The nearside lamp is taking on water. The seal hasn't broke and i can only think that when it rains, water is running down the Boot/rear wing junction and then over the lamp housing.
There is a sponge clamped between the lamp and the body so i dont think it would be there (i may be wrong).
Has anyone had this problem if so what was it and how did you get rid of it?
Thanks
Pete
There is a sponge clamped between the lamp and the body so i dont think it would be there (i may be wrong).
Has anyone had this problem if so what was it and how did you get rid of it?
Thanks
Pete
#2
Double check the seal cause i had a similar problem with sti rear lights on my my00. Eventually sealed round the lights when putting them in and again from the inside the boot once they were in have'nt leaked since.
#3
Thanks White Scoob
I have had the light off once when i dried the lenses but it has re-appeared. Should i put silicone sealant between the foam and the light?
Pete
I have had the light off once when i dried the lenses but it has re-appeared. Should i put silicone sealant between the foam and the light?
Pete
Thread
Thread Starter
Forum
Replies
Last Post
Scott@ScoobySpares
Full Cars Breaking For Spares
61
11 January 2021 03:08 PM
Scott@ScoobySpares
Full Cars Breaking For Spares
7
14 December 2015 08:16 AM
Mattybr5@MB Developments
Full Cars Breaking For Spares
20
22 October 2015 06:12 AM