JayCole

Just ordered clear side repeaters and clear indiscators for my P1 from Scoobyworld.

Are the Indicators easy to fit?

STi wanna Subaru

iTrader: (1)

Yes, very. One screw and they are out. I just got some from Tony on here and he swapped them over for me. 2 minute job

RESSE

iTrader: (1)

Jay,

The sides are a bit tricky to get in and out - be careful not to scratch your paint.

If I remember you slide the indicator cover to the front of the car and lever it out from the left.

Richard

JayCole

Cheers guy's, sounds easy enough.

They should be with me tomorrow hopefully - They cost nearly 100 quid!

Tone Loc

iTrader: (1)

Yep dead easy to do.... Guy bought mine and as he said dead easy to fit. The reason i went back to orange was the side indicatots were stolen so i didn't want the fronts going walkies aswell...... if the thick ******* thieves can nick mine without scratchin' the paint im sure you can do yours .

Tony.

AJT

Wendy @ Scoobyworld supplied same for my MY00. Piece of cake to fit. Just remember to keep hold of your orange indicators for the MOT as they're not 'approved'.

Mickle

Wendy sorted mine out as well, top company!

Mickle

p.s Get some silver bulbs, have done for mine now, it's a huge difference ;D

darkblueturbo

to revive an old thread...

I've got my clear sides - they were easy to fit.
I now want clears at the front - would be very grateful if anyone who's fitted them could give me a brief run down of how to do it. I'm MY00

Thanks

Brun

Un-screw single screw - remove and unplug unit - plug in new unit - stick it in the hole - replace screw.

darkblueturbo

**** brun, you make it sound too tricky...!!

I'll do my best.

Thanks mate

Brun

May the force be with you

markwild

I've just changed them on my 98MY.....

I've detailed instructions HERE

There's also some comparison photos of orange to silvatec bulbs on my site ...

Mark

darkblueturbo

excellent. I've got an MY00, but it shouldn't be too differnt, it's only the bumper that's slightly different.

cheers all
dan

StickyMicky

u dont need silver bolbes
dust a coating of silver paint on the orange ones and it works just as well

just do enough to cover the tango it still shines orange when lit

i did my vectra and nova lights like this