Fault code 13
#1
Scooby Newbie
Thread Starter
Join Date: Jan 2015
Location: Brighton
Posts: 19
Likes: 0
Received 0 Likes
on
0 Posts
Fault code 13
Hi I have no power to my spark plugs. The fault code comes up as 13. It means I have crank sensor working fine and it finds the camshaft sensor Can the camshaft pulley fail so it doesn't send a reading back to the camshaft sensor the wiring loom is fine and all connectors are good. This is the only fault code I have. Have I missed something very obviouse or could the cam wheel fail. The heads are off very early Ra 1992/1994 big valve heads Hope some one can help . Thanks
#2
Scooby Regular
iTrader: (9)
Hi I have no power to my spark plugs. The fault code comes up as 13. It means I have crank sensor working fine and it finds the camshaft sensor Can the camshaft pulley fail so it doesn't send a reading back to the camshaft sensor the wiring loom is fine and all connectors are good. This is the only fault code I have. Have I missed something very obviouse or could the cam wheel fail. The heads are off very early Ra 1992/1994 big valve heads Hope some one can help . Thanks
Have you reset the ECU after fitting th sensor as it may be a historic code.
#3
Scooby Newbie
Thread Starter
Join Date: Jan 2015
Location: Brighton
Posts: 19
Likes: 0
Received 0 Likes
on
0 Posts
Yes fitted new camshaft sensor. And it cleared the code and yes resetvthe ecu aswell the diagnostics says no fault. When I crank the car over it comes up with fault code 13 again. The old cam shaft sensor is in perfect working order so is the new one .
#5
Scooby Newbie
Thread Starter
Join Date: Jan 2015
Location: Brighton
Posts: 19
Likes: 0
Received 0 Likes
on
0 Posts
Yes have checked the timing its spot on I am looking for an early cam wheel and will fit to see if that will solve problem .I have later cam wheels but they don't fit the early camshafts .
#7
Scooby Newbie
Thread Starter
Join Date: Jan 2015
Location: Brighton
Posts: 19
Likes: 0
Received 0 Likes
on
0 Posts
Will be getting new sensor today from Subaru to see if that makes a difference and the wiring to the Ecu checks out fine. Thanks for your thoughts. Hopefully I can find the fault or the defective part ....?.