AEM 3.5 Bar Map Sensor P/N :30-2130-50
#1
Scooby Regular
Thread Starter
iTrader: (3)
Join Date: Mar 2004
Location: N.Ireland
Posts: 4,088
Likes: 0
Received 0 Likes
on
0 Posts
AEM 3.5 Bar Map Sensor P/N :30-2130-50
I have for sale the following:
AEM 3.5 bar 0.50 psi Map Sensor in as new condition.
This is a high quality AEM branded 3.5bar map sensor (0 to 50psi absolute).
Although usually used as a MAP sensor (manifold absolute pressure) this sensor is also suitable for use with oil and fuel.
The sensor has a 1/8 NPT male thread fitting but is supplied with a 5mm barb tail, a male AN4 (-4) adaptor and the 3 pin connector with pins and seals.
The sensor is made in the USA to military standards. This is a high quality sensor.
Sensor was only fitted to determine if there was a fault on car or not.
I am looking for £80
AEM 3.5 bar 0.50 psi Map Sensor in as new condition.
This is a high quality AEM branded 3.5bar map sensor (0 to 50psi absolute).
Although usually used as a MAP sensor (manifold absolute pressure) this sensor is also suitable for use with oil and fuel.
The sensor has a 1/8 NPT male thread fitting but is supplied with a 5mm barb tail, a male AN4 (-4) adaptor and the 3 pin connector with pins and seals.
The sensor is made in the USA to military standards. This is a high quality sensor.
Sensor was only fitted to determine if there was a fault on car or not.
I am looking for £80
Thread
Thread Starter
Forum
Replies
Last Post
Luckystrike
Subaru Parts
19
07 February 2017 10:59 PM
Luckystrike
Essex Subaru Owners Club
0
01 May 2016 11:48 PM
scottydouk
General Technical
5
27 October 2008 04:41 PM