Charlie H

This bar does just unbolt because I removed the whole lot to take two mountain bikes to scotland last year. Whether or not a split seat would fit though is a question I would like to know as well though. The "solid" rear bulk head is just some covered hard board and plastic sheeting.
Edited to say mine is a 93 WRX also

Hope this helps

[Edited by Charlie H - 5/2/2002 6:05:09 PM]

Tone Loc

iTrader: (1)

I've got a MY93 WRX wouldn't mind havin' a split fold rear seat. From what im told the WRXs have a solid rear bulk head, would this prevent the split fold seat being used?

Anyone know for sure if this is possible or not?

Cheers,

Tony.

Dyney

Err!! Yes!!!

If you have a solid rear bulkhead you will not be able to use a slit fold rear seat. Sorry!

Edited: 'cos I read the rest of the post.

[Edited by Dyney - 4/29/2002 5:24:59 PM]

Smiler1

Guys
When I fitted my rear strut brace to my 94 WRX I had to take the rear seat out. It had a steel box section bar which ran across the back of the seat. If this is the solid rear bulk head then as far as I can remember it can be un-bolted.

So I would think the rear seats can be swapped.

Cheers

S (ready to be proved wrong)

Tone Loc

iTrader: (1)

If it is that bit that stops you then i haven't got that neway!!!!!

Tone Loc

iTrader: (1)

Cheers for that Charlie.

Does anybody know if the P1 has a split fold seat? Thats based on the STi so if that does then i can too .

Tony.

Smiler1

Ahh but isnt the P1 a 2 door??

S

Tone Loc

iTrader: (1)

You're spot on, it is a 2 door but the rear seats are the same be it 2 or 4 door. The point is the 2 door type-r has a solid rear bulk head, therefore if the P1 has a split fold seat then the solid rear bulk head does not stop it being fitted.

Tony.