Flocking Question
#1
Scooby Regular
Thread Starter
iTrader: (6)
Join Date: Aug 2007
Location: Llanelli with a spanner in my hand!
Posts: 2,260
Likes: 0
Received 0 Likes
on
0 Posts
Flocking Question
I've made my own gauge pod and am going to get it flocked. The problem I have is that there is a lot of pin holes in the filler, which are becoming a pain to get out. I may try using some high build primer to fill them, in the meantime..
..will the flocking material fill/cover these holes, or will they show through?
Thanks, Rich.
..will the flocking material fill/cover these holes, or will they show through?
Thanks, Rich.
#4
Scooby Regular
iTrader: (7)
Join Date: Feb 2007
Location: Chichester, West Sussex
Posts: 1,178
Likes: 0
Received 2 Likes
on
2 Posts
why not use a final layer of much finer filler, to remove the pin holes?
I cant remember the names of any off the top of my head, but most manufacturers make a fine filler for pin holes etc.
I cant remember the names of any off the top of my head, but most manufacturers make a fine filler for pin holes etc.
Thread
Thread Starter
Forum
Replies
Last Post
Brzoza
Engine Management and ECU Remapping
1
02 October 2015 05:26 PM