I am looking at getting a boost gauge into my newage wrx.

My question is if I get an A pillar single gauge holder, what happens to the alarm sensor on the pillar. do the new gauge holders accomodate this or do you have to drill a hole or somthing?

example of what gauge holder below.

 

youll need to drill the hole, not a hasstle, im wondering this my self....

 

any one??? how to remove the old one

 

Thant's a lot of plastic for a single guage......have you considered a corner pod instead. I had one and it was easy to read.

Just a thought

Shaun

 

I moved mine further up so that it then screws into the original pillars location lug holding everything together pretty nicely



Its a co-axial cable.I cut mine and re-attached,then angled the sensor down a bit..worked fine for me

 

Elmer

Completely off topic but I just wondered where you got your pink STi pedals from

Shaun

 

There was a group buy,some years ago now(Simon Lau from Hong Kong?).I've just fitted those same ones to a 3rd different car now

 

Damn......I remember missing the group buy

Not seen any since !!

Thanks

Shaun