Help I am trying to remove the rear door cards from a jdm 95 wrx ( rattle from inside doors), so removed the hand well 1 screw that was easy, cup out no problem (still at peace with the world) ,pulled the door poppers off carefully, (none broken outstanding) ,but how on earth do I get the panel off there are no screws around the interior door handle area that I can spot,and it is getting to the point of brute force ( same situation last weekend but walked away) the card moves ish ! any help
before I start with a JIGSAW !!!!

 

This may help...

http://www.chiark.com/scooby/icetoc....n=5&subSection=*


--Sam

 

Thanks but it covers the later MY98 ,mine is a jdm my95

 

I removed the cupped shaped (no handle grab) 1 screw only. Then pull of carefully the inner door opening handle surround (plastic).
Then I start pulling the door card from the lower right side first & make my way around. Then push it up so it slides out. Then remove all the electrical connectors.
Some of the clips that hold the door card on mine broke so I had to replace them. Mind you the doors cards were on then off quite a few times. Just watch out for the black sticky sealant, if you get that on your interior it will be difficult to remove.

 

thanks I'll try that in the morning