Sparco Pedals...
#1
Scooby Regular
Thread Starter
Join Date: May 2002
Location: South West
Posts: 1,461
Likes: 0
Received 0 Likes
on
0 Posts
I have just purchased a set of Sparce pedals for fitting to my Scoob but before I start drilling holes in the exisitng pedals etc....has anyone fitted these ?? If so can you give me any hints and or tips in an effort to stop me from c0cking this up.
Cheers in advance
Cheers in advance
#2
Scooby Senior
Very tricky to line them up while avoiding the metal on the back of the pedel.
All i can say is line them up and line them up and do it again
The Brake and clutch are not too bad, but the loud pedel is a b1tch. On the reverse of it, there is a piece of metal which curves around and is attached to a spring thingy. I managed to locate one of my bolts right in the centre of where the curve is and the other just misses some metal further up. - does this make sense?
Anyway, i've mailed you a pic or two of the rear of mine, but my camera isn't all singing - all dancing so i hope they make sense to you
All i can say is line them up and line them up and do it again
The Brake and clutch are not too bad, but the loud pedel is a b1tch. On the reverse of it, there is a piece of metal which curves around and is attached to a spring thingy. I managed to locate one of my bolts right in the centre of where the curve is and the other just misses some metal further up. - does this make sense?
Anyway, i've mailed you a pic or two of the rear of mine, but my camera isn't all singing - all dancing so i hope they make sense to you