Jon T

Hi all. I am going to install a set of gauges and defi pod into my hawk tomorrow and was wondering where the best place to feed the sensor wires into the cabbin. Just had a quick look and the one thae seams the best is too close to the downpipe for my liking.
Any one have a better way to feed them from the engine bay to the top of the dash.
Thanks jon

asht88

That area is just fine have mine running there there all good.

Jon T

alcazar

iTrader: (2)

Also look at where the aircon pipes go through the bulkhead, low down, passeneger side.