Gauge sensor wires into cabbin
Hi all. I am going to install a set of gauges and defi pod into my hawk tomorrow and was wondering where the best place to feed the sensor wires into the cabbin. Just had a quick look and the one thae seams the best is too close to the downpipe for my liking.
Any one have a better way to feed them from the engine bay to the top of the dash. Thanks jon |
That area is just fine have mine running there there all good.
|
:thumb:
|
Also look at where the aircon pipes go through the bulkhead, low down, passeneger side.
|
All times are GMT +1. The time now is 11:05 AM. |
© 2024 MH Sub I, LLC dba Internet Brands