Install questions
01 September 2013, 07:50 PM
#1
Scooby Newbie
Thread Starter
Join Date: Feb 2011
Location: Fife, Scotland
Posts: 23
Likes: 0
Received 0 Likes
on
0 Posts
Install questions
Hiya Folks,
Just bought a Kenwood DNX5220 and Im just looking for some general install tips regarding placement of all the bits that come with it.
The unit is second hand and was sent in a manner I would never dream of. Needed a wipe down and tangled wires everywhere. (Hope it works)
What Im looking for is some advice on where to put:-
the Mic (Already suggested to put it at top of windscreen pillar but I have an alarm sensor there)
The Female USB connection
The Ipod connection (Comes with ipod connector and a male USB plug that Im guessing plugs into the female one to give me video from Ipod)
The GPS unit
The Bluetooth box
If some of you could tell me where yours are located and if theres any problems routing the cables there that would be great.
Dave
ps Cars a blobeye
Just bought a Kenwood DNX5220 and Im just looking for some general install tips regarding placement of all the bits that come with it.
The unit is second hand and was sent in a manner I would never dream of. Needed a wipe down and tangled wires everywhere. (Hope it works)
What Im looking for is some advice on where to put:-
the Mic (Already suggested to put it at top of windscreen pillar but I have an alarm sensor there)
The Female USB connection
The Ipod connection (Comes with ipod connector and a male USB plug that Im guessing plugs into the female one to give me video from Ipod)
The GPS unit
The Bluetooth box
If some of you could tell me where yours are located and if theres any problems routing the cables there that would be great.
Dave
ps Cars a blobeye
Last edited by Artful; 01 September 2013 at 07:53 PM. Reason: spelling
Thread
Thread Starter
Forum
Replies
Last Post
Brzoza
Engine Management and ECU Remapping
1
02 October 2015 05:26 PM