Struggling with Aerial connections on Hatch
#1
Struggling with Aerial connections on Hatch
Hi, need help please!
The standard 08 STi headunit is a Clarion & I'm trying to fit a Kenwood DNX to replace it. I've sourced the wiring adaptor & steering control adaptor lead & facia adaptor but have got stuck with the aerial connection. The lead from the car has the same diameter end fitting but it's too short for the female aerial connection on the kenwood unit. Tried Maplin & Halfords & looked at the autoleads PC5-143 but not sure that'll fit on the car side.
Anyone done a similar changeover?
Cheers, Steve
The standard 08 STi headunit is a Clarion & I'm trying to fit a Kenwood DNX to replace it. I've sourced the wiring adaptor & steering control adaptor lead & facia adaptor but have got stuck with the aerial connection. The lead from the car has the same diameter end fitting but it's too short for the female aerial connection on the kenwood unit. Tried Maplin & Halfords & looked at the autoleads PC5-143 but not sure that'll fit on the car side.
Anyone done a similar changeover?
Cheers, Steve
#6
Piccies:
Kenwood
Car
Think you can make out that the end piece from the car side ain't long enough to go in the recepticle on the kenwwod unit. If the lead from the car wasn't at a right angle it would push in far enough but because it is, it doesn't!
Cheers, Steve
Kenwood
Car
Think you can make out that the end piece from the car side ain't long enough to go in the recepticle on the kenwwod unit. If the lead from the car wasn't at a right angle it would push in far enough but because it is, it doesn't!
Cheers, Steve
Last edited by STEVECHAPS; 23 May 2011 at 10:19 AM.
Thread
Thread Starter
Forum
Replies
Last Post
fatboy_coach
General Technical
15
18 June 2016 03:48 PM