matty01

ie quick ,pleeaase ,half way through job . Only one head unit output(ie one pair)but i need to power two amps in boot should i split the signal at head unit or at amps or is there a more proffesional way? Please

BigRed

I would put the splitter at the amp end , it will be better if that is your only alternative because you will have to run only one set of RCA leads, remember splitting will half the output from the head unit to the amps. Don't you amps have a link through facility???

[Edited by BigRed - 7/14/2003 8:14:13 PM]

matty01

link through? err they may have (they are not the same make ...)How is link through usually achieved? can't see any markings/mention of it....

Nick n Jewels

Matty you joining us on Sunday for Lincoln meet?

jewels

Si.t

no need - use the spliter to make 4 channels from two and feed both amps off the splitter (isn't that the People's front of judea??? )

matty01

I may well do Jewels....sounds good...

BigRed

my viper amps have extra rca outputs for a link to other amps, don't no if your amps have this function, have a look at the connections if there is only one pair of RCA connectors on the amps then you need splitters.

matty01

It has three pairs of rca inputs two pairs marked input one pair marked pre-out which i presumed meant "connect the head unit pre-out here.." but i suppose could mean "this is the amps' own pre-out ,you muppet" to use as a link ,is this likely to be the case do you reckon

matty01

Found it in the destructions it is a pre-out can't be too carefull,don't want to melt my new amp , cheers guys ,**rushes out to finish car**