John WRX

Due to the previous thread being deleted ive had to put this up for information.

All sunstrips for which payment has been received will be going out later this week.

Cheers.

Paulo P

iTrader: (42)

Thanks John

Aztec Performance Ltd

iTrader: (234)

Why was it deleted?

Paulo P

iTrader: (42)

It was thought that John is a trader or is close to a trader which is not allowed in the T&C's of the board. This thread has now been setup by John so that he can contact customers who have paid etc.

Thanks

John WRX

Currently under investigation but shouldnt be any problems.

John

MichaelH

Cheers John.

Just wondering, what are the chances of getting them before Sunday? Off to santa pod for a run out, would love to have them on by then if poss?

John WRX

Due to send them out tomorrow so possibly but i cant promise, sorry mate.

DJM

Hi John

Sent my cheque on Sunday - can you confirm if you have it yet?

MichaelH

Cheers John. No worries, I'll just cross my fingers.

I'm sure royal mail won't let me down...

John WRX

Sunstrips have just gone in the post to the following................

Peanuts
Dave Phillips
SPEN555
mag 6/4
Micheal H
DJM
SIM ONE

Many thanks for your orders and if you require further items you know where i am.

Peanuts

iTrader: (15)

matscooby

iTrader: (3)

John did you get my cheque.

John WRX

underwriter - Cheque arrived this morning. Will sort them this week for you.

Matscooby - not yet

matscooby

iTrader: (3)

I sent the cheque last Tuesday, could you confirm your address by PM please.

Peanuts

iTrader: (15)

arrived yesterday, looking good!

cheers for this, destructions are *ok*

Underwriter

cheers John , no rush mind you HUGE stone smashed windscreen today

SPEN555

I received mine.

Couple of questions regarding the instructions.

Wot the hells meant by a flat edge? The whole thing has flat edges? I have measured the one length and it is longer than the other side. I presume the narrower length goes to the top of the screen? Wot's the 22" measurment about? Wot do you use to trim it with? A stanley knife is out of the question as you would scratch the windscreen?

Sorry for all the questions but the instructions make very poor reading to me and don't logically relate to one another. Also, I want to get it clear in my head before tackling it as I don't want to make an ar$e of it.

There is also no guide on how to line up the overlay sticker or am I missing something?

Damian.

John WRX

Spen........

Turn you backing over, you will see rows of squares, there will be a straight edge and a wavy edge. Straight edge is to go on the windscreen.
look at your bonnet, there are 2 corners near you windscreen at the bottom corners of the screen yeah??? Put a piece of masking tape on the windscreen rubber and measure up 22 inches from these 2 corners of the bonnet and put a mark on the masking tape.
Stanley blade for trimming - correct, you dont scratch the windscreen at all, you are triming tight up between the rubers and screen to form a flush fit.
Overlay sticker - Simple, find the middle of it mark it, line up with interior mirror, make sure its straight, stick down.

SPEN555

Cheers John,

Bit clearer for me now.

Damian.

sim_one

i thought you were going email pics of car to show me decals m8

DJM

anyone got any photo's of theirs done? and on their car