Hi All,

I'm swapping my TD04 out soon for a FE TD05 16G, I'm collecting everything before I start, so I've got new exhaust gaskets, studs, nuts etc etc.

I think the oil feed washer is M10 at the turbo end and where it connects to the block is M12, but does anyone know the thickness? Is it 1.5mm?

Cheers,

 

just use the washers again.

 

as above just anneal them and they are as good as new.

 

I've heard that they're likely to leak? They're also dirt cheap to buy so I'd rather have the piece of mind knowing they're new.

Just need to know the thickness so I can get some ordered.

 

its up to you, my brake fluid hasn't leaked yet.

 

I never anealed my turbo washers and ive had them on and off twice now, no leaks.
Id say more like .8-1mm thick if your that set on changing them, but 1.5mm would do, it wouldnt matter one bit.

 

Ordered some HEL M10 and M12 copper washers

 

be funny if they leak lol

 

Lol.

 

Had to laugh at boosteds comments hehe