1997 uk 2000 turbo with apexi ecu wanting to revert to standard but have issues?
#1
Scooby Newbie
Thread Starter
Join Date: Aug 2013
Location: Hastings,East Sussex
Posts: 26
Likes: 0
Received 0 Likes
on
0 Posts
1997 uk 2000 turbo with apexi ecu wanting to revert to standard but have issues?
Hi guys pretty new to this forum but have been lurking about for a while, right hope its ok to post this iv got a 1997 uk 2000 turbo that has a 3 plug wiring harness to ecu, im wanting to revert back to the s-8 ecu which was supplied with the car when I bought it.
My issue is first of all tried just swapping it over and the car just wouldn't start, so looked up and came across a very old thread linky but for some reason this guide don't add up for me in using it in reverse to installation of reverting the wiring back.
I am now confused I look at my wiring and the 7 connector was in 8 pin on the b137 plug?? this was as far as I went as don't want to damage nothing.
One last thing is there an easy way of removing the connectors out of the harnesss plug without damage help would be very much appreciated right now :-)
My issue is first of all tried just swapping it over and the car just wouldn't start, so looked up and came across a very old thread linky but for some reason this guide don't add up for me in using it in reverse to installation of reverting the wiring back.
I am now confused I look at my wiring and the 7 connector was in 8 pin on the b137 plug?? this was as far as I went as don't want to damage nothing.
One last thing is there an easy way of removing the connectors out of the harnesss plug without damage help would be very much appreciated right now :-)
Thread
Thread Starter
Forum
Replies
Last Post
blockhead
Subaru Parts
19
07 November 2015 11:50 PM
matt12
ScoobyNet General
64
16 September 2015 09:16 PM
matt12
Engine Management and ECU Remapping
4
14 September 2015 09:36 AM