Newage gearbox into a classic
#1
Scooby Regular
Thread Starter
Newage gearbox into a classic
My question is. I know it's possible to put a gearbox from a newage WRX into a classic impreza, but it's it just a straight swap or does anything else have to be changed in order for it to work.
Thanks
Matt
Thanks
Matt
Last edited by Matt23; 25 November 2013 at 05:25 PM.
#2
Scooby Regular
iTrader: (7)
Join Date: Apr 2007
Location: on the computer.... obviously!
Posts: 545
Likes: 0
Received 0 Likes
on
0 Posts
Depends on what age your'e putting it into, the early engine blocks only had 4 bolt holes tapped at the bell housing. That's not a problem except the newage gearbox doesn't have a threaded hole for the starter motor bolt like the classic does. It has a drilled hole for a longer bolt to go right through into the block, the early block has no metal where this threaded hole is in the newage block.
The easiest way to get round it is to run an m10 thread tap down the gearbox hole and use a shorter bolt to secure the starter.
The easiest way to get round it is to run an m10 thread tap down the gearbox hole and use a shorter bolt to secure the starter.
#3
Scooby Regular
Thread Starter
Depends on what age your'e putting it into, the early engine blocks only had 4 bolt holes tapped at the bell housing. That's not a problem except the newage gearbox doesn't have a threaded hole for the starter motor bolt like the classic does. It has a drilled hole for a longer bolt to go right through into the block, the early block has no metal where this threaded hole is in the newage block.
The easiest way to get round it is to run an m10 thread tap down the gearbox hole and use a shorter bolt to secure the starter.
The easiest way to get round it is to run an m10 thread tap down the gearbox hole and use a shorter bolt to secure the starter.
#5
Scooby Regular
Thread Starter
Thread
Thread Starter
Forum
Replies
Last Post