Notices

Engine rebuild on blobeye,oil passing on cylinder

Thread Tools
 
Search this Thread
 
Old 22 November 2013, 05:54 PM
  #1  
BIG EBO
Scooby Newbie
Thread Starter
 
BIG EBO's Avatar
 
Join Date: Nov 2013
Location: Scotland
Posts: 2
Likes: 0
Received 0 Likes on 0 Posts
Default Engine rebuild on blobeye,oil passing on cylinder

Hi guys I'm new to site

Recently got the dreaded 50000 3rd crank nock blobeye sti 2004

Had my engine rebuilt with wossner forged pistons cranks and updated x drilled black crank,,got the car back and was running it in as should be for 1000m all done then got oil changed garage gave the ok,, noticed there was slight white smoke if I was idling or parked for few minutes,,turbo was checked and is fine little oil passing,,spoke to repairer today and there saying I have some oil running up one off the cylinders,,they done compression test and pressure test and it's ok,,car sounds so smooth,any ideas guys before my brain melts

Also lost boost but this could be due too manifold coming from turbo leaking


Cheers

Last edited by BIG EBO; 22 November 2013 at 08:38 PM.
Old 23 November 2013, 05:20 AM
  #2  
p1junkie
Scooby Regular
iTrader: (5)
 
p1junkie's Avatar
 
Join Date: Jun 2008
Posts: 817
Likes: 0
Received 0 Likes on 0 Posts
Default

any smoke is oil being burnt which shouldnt be happening
if its a forged engine then when cold there could be a small whiff but certainly not after car is warm as the pistons shld have expanded to their correct clearance by then
Old 29 November 2013, 12:35 PM
  #3  
BIG EBO
Scooby Newbie
Thread Starter
 
BIG EBO's Avatar
 
Join Date: Nov 2013
Location: Scotland
Posts: 2
Likes: 0
Received 0 Likes on 0 Posts
Default

Hi cheers for reply.

Engine is seaping oil throu exhaust valves so have ordered new seals too se if that's the culprit,fingers crossed




All times are GMT +1. The time now is 05:27 AM.