Downpipe to mid pipe gasket
#1
Downpipe to mid pipe gasket
Hi all
I,m decat ting the mid pipe tomorrow but I'm struggling to find a gasket that fits between the downpipe and mid pipe , it looks like a standard one but its a bit longer , I've had a standard up to it but the holes on the standard gasket fall short on the holes on the mid pipe , does anybody know where I can get one from or should I just make the holes on a standard one longer and use some high temp gasket seal with it .
Thanks in advance . Kev
I,m decat ting the mid pipe tomorrow but I'm struggling to find a gasket that fits between the downpipe and mid pipe , it looks like a standard one but its a bit longer , I've had a standard up to it but the holes on the standard gasket fall short on the holes on the mid pipe , does anybody know where I can get one from or should I just make the holes on a standard one longer and use some high temp gasket seal with it .
Thanks in advance . Kev
#4
It a 2.5 bore , it's not the cone gasket or some call it a donut gasket that's at the end that connects to the centre section , this is the other side that connects to the downpipe where the cat is and it's a flat end .
Here's a picture , I'm after the one titled "this one"
Here's a picture , I'm after the one titled "this one"
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
28
28 December 2015 11:07 PM
Mattybr5@MB Developments
Full Cars Breaking For Spares
12
18 November 2015 07:03 AM