crazyspeedfreakz

iTrader: (92)

What's the best way to cut the hole in the wing ? Fitting a hdi tomorrow just thought I'd ask for abit of advice before I start.. I've got tin snips at the ready

Also Is it worth me insulating the pipe that goes over the top of the turbo for the fmic with heat wrap just wondering if this is worth while

Also any other advice on what I should be looking out for would be great !



Cheers

Csf

crazyspeedfreakz

iTrader: (92)

Bumppp

RICHARD J

iTrader: (4)

The best way to cut the hole is a plasma cutter but I doubt you've got one so drill some holes & join them with a jigsaw. Tidy the rough edge by slicing along the edge of a vac pipe & pushing it on to the rough edge after sealing with paint. Yes I'd wrap the hard pipes in White but not essential.

subnoobX

Just in case if you need it, they have the installation guide online too =D
http://www2.hybrid-power.com/installation/

sonic93

iTrader: (16)

Richard said best way and with vac pipe. So looks spot and don't lose fingers. Take your time with bumper don't butcher it. You fitted turbo then?